江苏Copper plated round steel

Copper-plated round steel is suitable for grounding construction under various conditions such as soil moisture, temperature, PH value and resistivity. The copper-plated round steel manufacturer's construction is simple and fast, and it can be installed manually or mechanically, which greatly improves the construction efficiency through micro-creation. Copper-plated round steel has high strength and is suitable for deep excavation above 35m underground.

Copper-plated round steel has good corrosion resistance, uniqueness, and a service life of more than 50 years, which can greatly reduce the labor intensity of maintenance. The power supply should be checked normally before use to make sure it is de-energized, then make sure there is no voltage present on the device. Start by attaching the ground clips to a grounding grid or a piece of flat iron, then use a ground rod to tighten each end of the equipment wire.

It must be stored properly and carefully inspected before each use for good condition with no exposed soft copper wires and no loose nuts. Otherwise, it should not be used. Reverse the above sequence when removing the shorted ground wire. As one of the more common lightning protection products, it has many advantages such as good conductivity, low resistance, good corrosion resistance, convenient transportation, convenient construction, and high construction efficiency.

Copper-plated round steel adopts electroplating process, continuous casting and other production processes, and the surface of the special steel core is covered with a new grounding body made of 99.9% pure copper. Conductivity can be the same as copper rods of the same diameter. However, the cost of the project is much lower than that of the all-copper pipe, and the anti-corrosion performance is much better than that of the hot-dip galvanized pipe, and it can also be replaced. Traditional grounding materials such as round steel, angle iron, galvanized flat steel, etc.